fire detectors


Dual Action Addressable Manual Pull Station



The Dual Action Addressable Manual Pull Station is a state-of-the-art,dual-action device (i.e., requires two motions to activate) that includes an addressable interface for Apollo compatible addressable fire alarm control units (FACUs).

Duct Smoke Detectors




The Apollo Duct Smoke Detector provides early detection of smoke in the air moving through heating and ventilation (HVAC) ducts in commercial and industrial premises. Its purpose is to prevent the recirculation of smoke from an area on fire to areas unaffected by the fire.

Minidisc Remote Indicator




The MiniDisc remote indicator ia a light-weight, compact indicator for use in fire protection systems. The indicator may be used in all installations incorporating Apollo detectors, including Series 65TM, AlarmSense®, Orbis®, XPlorer, XP95®, Discovery® and I.S. detectors.

Open-Area Alarm Devices




The Open-area Alarm Devices are loop-powered, wall mounted devices which are connected to any XP95® or Discovery® system. The range comprises sounders, beaconsand sounder beacons, all designed to fit to a common mounting base.

Short-circuit Isolation in XP95® and Discovery®



Analogue addressable fire detection systems are usually designed as loops, with the connecting wires atarting and finishing at the control panel.

Waterproof Addressable Manual Call Point



The Waterproof Addressable Manual Call Point has been designed to operate on a loop of intelligent fire detection devices and when activated interrupts the polling cycle for a very fast response.

XP95 Manual Call Point




The XP95 Manual Call point has been designed to operate on a loop of intelligent fire detection devices and when activated interrupts the polling cycle for a very fast response.

XP95 Sounder Control Unit With Isolator



The XP95 Sounder Control Unit with Isolator is used to control the operation of a zone of externally powered sounders and to report their status to Apollo compatible control equipments.

XP95 Switch Monitor With Isolator




The XP95 Switch Monitor with Isolator is designed to monitor the state of one or more single pole, volt-free contacts connected to single pair of cables and to report the status to Apollo compatible control equipment.

XP95 Three Channel Input or Output Unit



The XP95 Three Channel Input/Output Unit is available in the following options: in a plastic enclosure, in a plastic enclosure and with built in bi-directional short-circuit isolator, as a printed circuit board(PCB) and as a PCB and with built-in-bi-directional short-circuit isolator